Note: This post carries on from Part 3.
Testing & Reporting
Now that you’ve set up your lab, you can start working on the VSHs.
Test #1 – TCP Options
Usually when telnetting between two routers (e.g PC-A-01 and PC-B-01), the MSS negotiated is 536 and no other options are specified. However, after configuring the VSHs to optimise telnet traffic, you can see the VSHs and Enhanced Auto discovery in action:
These enhanced settings won’t make much of a difference where Telnet traffic is concerned, but this sort of test can be useful for those who cannot run the Windows XP VMs due their PC’s performance.
Note: This post carries on from Part 2.
Now that the vSwitches are set up, the next thing you will need to do is install the VSHs.
1) Through the vSphere client, install the VSH by clicking on “File” > “Deploy OVF Template”.
2) When asked for the name of the VM, type “VSH-A”.
3) When configuring the NICs, match the “Source Networks” to their appropriate “Destination Networks”, as per the image below.
Note: This post carries on from Part 1.
SW1 and SW2 have been used to allow multiple devices to connect to the VSH’s Primary, Auxiliary and lan0_0 subnets. You can either use trunk ports or access ports between the switches and R3 and R5. If using access ports, you’ll need a total of six ports per switch:
|Switch Port #:
||VSH-A Primary interface
||VSH-A Primary Interface VLAN
||VSH-A Auxiliary interface
||VSH-A Auxiliary Interface VLAN
||VSH-A lan0_0 interface
||VSH-A lan0_0 Interface VLAN
A little while back I began looking into WAN optimisation, and in particular, Riverbed’s Steelheads. I really enjoyed all that I was reading so decided it was time to fire up a few Virtual Steelheads in my lab. As was the case in my Connecting the NetApp Simulator to your Virtual and Physical Labs and Trunking VLANs between the NetApp Simulator and GNS3 posts, GNS3 again plays an instrumental part in getting this lab up and running.
The reason why I have called this a “Self-Contained” lab is because, as you will soon see, it demonstrates you how can replicate a real-life setup using a single PC or laptop with the following applications:
- GNS3 (installed on your PC)
- VMWare Workstation (installed on your PC)
- Two Windows VMs (running in Workstation)
- Two ESXi hosts (running in Workstation)
- Two Virtual Steelheads (one installed per ESXi host)
(With all of this virtualisation inside of virtualisation taking place, I can’t help but think about the movie Inception) :)
Before jumping into the configuration details, I’ll run through a few things which you will need to know in order to complete the setup.